26
Method B
The setting has two steps:
4. Choose area
Move the cross to the centre of desired position, call preset 1 to save the position then go to step 2 or call preset 2 to cancel.
5. Set size
Move up, down, left or right to adjust the size, call preset 1 to save or call preset 2 to cancel.
Note: One screen has limited number of privacy mask. If the masking number exceeds, system will pop up an alert message: ‘Position Error’.
User can choose other place or delete other masking to set a new one.
z
Activate:
To indicate whether this privacy masking is existing or not. (Empty: Not set. Open: Existing)
z
Delete :
To delete current privacy masking.
5.10 Alarm Setup
System Menu > Alarm Setup
z
Alarm Input:
Select the number of alarm input channel (1-7).
z
Alarm Mode:
Auto or manually set alarm.
-
Auto:
Dome will set alarm based on Arm Time and DisArm time.
-
Manual:
Manually set alarm in following item
z
Set Alarm:
Arm off or Arm on.
-
Set Alarm:
Arm off or Arm on (Disable or enable the alarm input channel)
z
Input State:
Select current alarm input channel’s normal state. NO or NC ( normal open or normal close).
z
Run Function:
Set auto respond function.
-
Off
-
Preset (001-220)
-
Panning (1-4)
-
Pattern (1-4)
-
Sequence (1-4)
z
Alarm Output:
Select respond output channel for current input channel. Off, 1, 2, 1&2.
z
Reset Delay:
Set the time that system will auto reset the alarm after current alarm inputs
-
Values:
1 second to 255 second.
z
Arm Time:
Set the alarm enable time.
z
DisArm Time:
Set the alarm disable time.
Note: It only takes effect when alarm mode is set auto.
Call Preset 1 :Save
Call Preset 2 :Cancel
Move Dome
Alarm Setup
1. Alarm Input
:1
2. Alarm Mode
:Manual
3. Set Alarm
:ArmOff
4. Input State
:NC
5. Run Function
:Off
6. Alarm Output
:Off
7. Reset Delay
:1s
8. Arm Type
:00:00
9. DisArm Time
:00:00
0. Back
Summary of Contents for XPS036
Page 6: ...6 4 System Connection ...
