XVision XPR16H, User Manual

Page: 79 / 122

XPR16H - User Manual
79
7.1.2 On WAN
There are two ways to connect to the DVR over the internet, detailed below as follows:
Connecting via a router or a dynamic DNS account:
Note: This DVR only supports the following providers: www.dns2p.com, www.meibu.com, www.dyndns.com and
www.no-ip.com
. Please refer to section “4.6 Network Configuration” for further details.

Step 1: Go to Main Menu > Setup > Network > (refer to Fig 4-34).
Please ensure that the “network” and “Sub-Stream”
settings are correctly configured (refer to “4.6.1 Network Configuration”).

Step 2:
The user then needs to configure their router for “Port Forwarding”. This can be done by going to the configuration
interface of the router and then mapping the server port and IP address
. For further details on “Port Forwarding” please
contact technical support.
Note:
“Port Forwarding” settings/techniques may vary with different manufacturers. Please contact your internet service
provider (ISP) or the router manufacturer/manual for further assistance.
.

Step 3: Open Internet Explorer and input the IP address (Static address), or dynamic domain name and enter. If HTTP
port is not 80, add the port number after IP address or domain name.

Step 4: IE will download ActiveX automatically. Then a window pops up and asks for user name and password.

Step 5: Input name and password correctly, and enter to view.
Note: If you cannot download and install ActiveX, please refer to
” Appendix A
” FAQ Q7.