Change Screen Display under Live Mode
Display Mode ( )
Press once at a time to switch the screen display
4ch: Full/quad screen display selection
8ch: Quad/8-way screen display selection
16ch: Quad/8-way/16-way screen display selection
PAGE ( )
Press MODE+ to switch page of screen display
4ch: Not applicable
8ch: 1st Quad/2nd Quad screen display switching
16ch: Quad mode: 1st Quad/2nd Quad/3rd Quad/4th Quad screen display switching
8-way mode: 1st 8-way/2nd 8-way screen display switching
SEQ ( )
Press MODE+ to switch page of screen display
4ch: 1st Full > 2nd Full > 3rd Full > 4th Full > Quad > 1st Full....
8ch: 1st Full > 2nd Full > 3rd Full.... > 8th Full > 8-way > 1st Full....
16ch: 1st Full > 2nd Full > 3rd Full.... > 16th Full > 16-way > 1st Full....
Motion Area Setup
Select ‘Motion Area’ under the selected camera. The previous Motion Area will show on the
screen when you enter. Use
to move the cursor to the beginning point (upper
left) of your first detection zone, then press for confirmation.
Move the cursor to the end (bottom right) point of the zone and press for confirmation.
The cursor will then appear for you to set up your next zone. Repeat the process until you have
set up to four zones. Press to complete the motion setup (‘
Motion set up OK
’ will be shown
on the screen).
Adjust
Alarm REC
if your DVR is NOT in 24-hr REC Mode. Video Motion detection (VMD)
function will be enabled
ONLY if
the ‘Motion’ has been turned ON; and one detection zone
(minimum) has been set up.
REC Schedule Setup
Please make sure the
REC Mode
under
Display/Record
is in
Schedule
mode, and enter the
desired time into
Setup REC Schedule
under
Others
.
Confirm Alarm Buzzer
Once the alarm has been triggered, the screen will switch back to the original screen display.
Push the button with the corresponding channel number.
Chapter 4
General Operations
15
