XtremeAIR XA41, Maintenance Manual

Page: 248 / 284

Maintenance Manual XA41/XA42
AMM-XA42-0040-001 C.00
Page 2 Page date:
Chapter 76 25.09.2018
76-00-00 GENERAL
The engine controls include the throttle control, the propeller control, and the mixture
control.
76-10-00 THROTTLE CONTROL
The throttle is operated with a throttle lever on the left side of each cockpit and a Bowden
cable.
Figure 76-1: Throttle control linkage.
If the throttle control linkage is different than the one illustrated in Figure 76-1, perform SB-
2013-005.
To adjust the throttle, change the length of the rod end. The rod end connects the forward
end of the Bowden cable to the operating lever on the injector body. Thus, the full operation
range is available, from idle to full throttle.
To remove the throttle control grip and rod for S/N 01 – 07 and S/N 101-150, refer to
chapter 39-30-00:
To remove the throttle control grip and rod from S/N 151 on, or after performing SB-2017-
014:
To replace throttle track and traveler:
1
Remove the connection between the front and rear handle. Pos.14 from Figure 76-2.
2 Remove safety wire and screws from the handles. Pos. 12 and Pos. 13 from
Figure 76-2.
3 Replace track and traveler. Refer to Figure 76-3 and Figure 76-4.
5 Reassemble in reverse order and safety wire. Perform a functional check of the
throttle control.