www.XtremeAirUsa.com
PAGE
6
INSTALLATION
A. PREPARE DUCTWORK & SINGLE OUTLET
Make sure you have a 15amp, 120V, 60Hz, single outlet on the
left or right of the duct pipe (usually is on ¼ of cabinet width).
See Figure 1
Make sure duct pipe is ready to hook up to the range hood before
beginning installation (8” diameter duct, and roof or wall cap,
depending on where you will be venting your hood)
NOTE: Use threaded drywall anchors only when mounting the hood on
sheet rock. Mounting the hood on wall studs or lumbers is highly
recommended.
B. INSTALL THE HOOD BODY UNDER A CABINET:
1.
Put a thick, protective covering over counter top, cook top or range
to protect from damage or dirt.
TIP (optional): you can create a solid flat form by having 2 solids 2-3”
block at both side of stove and a 3/4”-1” plywood flat form above. Figure 2
2.
For installing under the cabinet with recessed bottom, attach 4-inch
wide wood filler strips (not provided) on each side. Refer to below
figure 3
3.
Create access opening for electrical wires and hood exhaust under
the cabinet. Figure 4
4. Lift the hood up and have it
place below the cabinet. Make
sure center the hood beneath the
cabinet and flush with the front of
the cabinet figure 5
TIP (optional)
: since the hood is
heavy, use cabinet jack is highly
recommended it. See figure 5-5
Figure 2
Figure 3
Figure 1
Figure 5
Figure 5-5
Figure 4
09
