Xtreme Power 196CC, Owner'S Manual And Safety Instructions

Page: 12 / 28

12
GB
Installation of the cotter pin is
important and required. Failure
to install the cotter pin can result
in loss of wheel retention. Always
assemble using a new cotter pin. Do
not reuse.
Tank & Tongue
1. Attach the Tongue & Stand to the Tank
& Engine with Hex Bolt M12
×
110 mm, Flat
Washer, Lock Washer and Hex Nut in two
places. Tighten securely using 19mm socket
wrenches.
Wheels
1. Remove disposable spindle covers and
wheel bearing covers.
2. Slide Wheel/Tire to the spindle with valve
stem of tire facing outwards. Install the
Flat Washer onto the spindle. Thread the
slotted Castle Nut onto the spindle. The
slotted nut should be attached with a 28mm
socket tight enough to eliminate the free-
play of the wheel assembly and not tighter.
Make sure the wheels can freely rotate. The
Castle Nut needs to be oriented to allow
for the installation of the Cotter Pin. Install
the Cotter Pin through the Castle Nut and
spindle. Bend pin ends around spindle to
secure its position. Install the Hub Cap using
the Hub Cap Tool . Gently tap on the hub
cap tool with a hammer to drive the hub cap
into place. Repeat these steps to install the
2nd wheel.
2. Remove the cap from the manual canister.
Align the holes in the manual canister with
the holes in the tongue. Insert and tighten
bolts and washers. Put the cap back on the
canister.
M12 x 110
(
×
2)
M6 x 20
(
×
3)
M6
×
20
×
3
C
M12 x 110
(
×
2)
M6 x 20
(
×
3)
M12
×
110
×
2
B
×
2
A
× 1
ASSEMBLY ASSEMBLY