1 3
include some or all of the following:
To broadcast a warning when power fails.
To close any open file before the battery is exhausted.
To turn-off the UPS.
Some computers are equipped with a special connector to link with the
communication port. In addition, special plug-in cord may be needed. Some
computers may need special UPS monitoring software. Contact your dealer for the
details on the various interface Kits.
Attention:
UPSMON software and interface port function just available for
model name
with “P” affix. The standard RS-232 cable (pin to pin D-SUB 9 pin cable) can be
connected
between UPS REMOTE PORT and computer COM port for the UPSMON series
software.
UPSMON software can be free download from
www.xpcc.com
6. Battery Cabinet
6.1 Battery’s life of UPS
The battery’s life of UPS is about 3-6 years under normal usage.
6.2 Battery Replacement
Once the UPS’s battery is no longer useful and must be replaced. Please call the
service personnel to replace it.
Appendix a Troubleshooting
UPS has a self-protect feature that prevents the UPS from being
damaged as a result of overheating. If the temperature is higher than
55
°
C, wait for a while and allow t the UPS to cool down..
1 4
Problems Possible
Cause
Solution
Full-time Bypass
outlets stop providing
power to the
equipment
Circuit breaker button
popped up as a result of
overload.
Unplug at least one piece of
equipment from the Full-time Bypass
outlets.
Switch off UPS, wait 5 seconds, reset
the circuit breaker (press down
breaker button), then switch on UPS.
Battery undercharged or
depleted due to frequent
power outages.
Recharge the battery by leaving the
UPS plugged in and switched on.
The power required by your
equipment slightly exceeds
the capacity of the UPS.
Unplug at least one piece of
equipment from the UPS outlets.
UPS doesn’t perform
to its expected
runtime.
The battery is slightly
worn-out.
Call the service personnel to replace
the battery.
Special UPS is designed to
prevent damage from
flipping.
Switch UPS off, wait for 5 seconds,
then switch UPS on.
The battery is worn-out.
Replace the battery by following the
instructions in this manual.
UPS cannot be
turned on.
Mechanical problem.
Contact your sales representative.
Appendix b Specifications
MODEL 600VA
1000VA
1200VA
Input Capacity
(On
Battery)
600VA/360W
1000VA/600W
1200VA/720W
(Surge
protection)
500VA 500VA 500VA
Voltage
+/-25% at line input
Frequency
50 or 60 Hz +/-10% (auto sensing)
Voltage (on battery)
Simulated sine wave at 100V/115V/230V +/- 5%
Output
Frequency (on battery)
50 or 60 Hz +/- 0.5%
