www.XtremeAirUsa.com
PAGE
7
STEP 3: Install support brackets
STEP 4: Install Chimney
Important note: first make sure your ductwork is pulled down about 6 inch longer than the chimney
.
STEP 5: Attach Hood Body
MODEL PX04-I36, PX04-I42, PX05-I36, PX05-I42, PX06-I36, PX06-I42 – SKIP THIS STEP
1.
Attach multiple hoses brackets vertically outside the 4
corner of the ceiling bracket as show in Figure 3A.
Figure 3A
2. Attach brackets vertically inside of the 4 multiple holes
brackets installed in previous step (3A).
Note: make sure extend the brackets to the appropriate
length. (the bottom of the hood should be 26”-30” above the
cook top)
1.
Slide inner and outer chimney sleeve over support
brackets, covering the ceiling bracket
2.
Screw inner chimney into place at the top of ceiling
bracket
3.
Lift the outer chimney all the way up to ceiling, USE
screw driver to hold it from falling down
Note:
To avoid scratching the chimney, extend the inner upper
chimney
slowly
and
carefully
to the chimney-mounting
bracket
Mount the canopy glass to the hood.
