Mounting tool bits
Warning: before do it, make sure unplug the machine!
Inserting
Clean and lightly grease the shank end of the tool.
Push back the Flex Sheath and insert the the tool.
Pull the drill bit to make sure it is locked completely.
Removing
Push back the Flex Sheath and remove the tool.
CAUTION:
The insert tool may become hot duringUse.
There is a risk of burning the hands. Wear rotective
gloves when changing insert tools.
How to replace grease
This machine is if full air-tight construction to protect against dust and to prevent lubricant leakage.
Therefore, the machine can be used without lubrication for long periods. Replace the grease as
described below.
ACUTION:
Before replenishing the grease, turn the power off and pull out the power plug.
1. Loosen the four set screws and remove oil tank cover.
Wipe off the grease inside.
2. Supply 30g of XINPU Demolition Hammer Grease
(Standard accessory, contained in tube) to the
Crank Housing. Too more or too little will cause the
machine non-properly work.
3.After replenishing the grease, Install the oil tank cover
Securely.
4.Clean the machine.
Maintenance and inspection
Before do any maintenance, ensure unplug the plug.
1. Inspecting the demolition hammer
Use a dull accessory, such as bull point, cutter, etc., will cause motor malfunction and efficiency
degraded. Replace with a new one when your accessory is abased.
2. Inspecting the mounting screws
5. Maintenance
