Additional Safety Rules for Hammer
1.
Wear ear protectors.
Exposure to noise can cause hearing loss.
2.
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3.
Hold power tools by insulated gripping surfaces, when performing an operation where the cutting tool may
contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire
may make exposed metal parts of
the power tool "live" and could give the operator an electric shock.
4.
W
ear a dust mask
.
Do not inhale the harmful dusts generated in drilling or chiseling operation. The dust can
endanger the health of yourself and bystanders.
5.
Be sure the bit is secured in place before operation.
6.
Under normal operation, the machine is designed to produce vibration, the screws and bolts can come loose,
causing a breakdown and accidents. Check tightness of them carefully before running.
7.
In cold weather or a long time tool not be used, please keep the tool running without load a few minutes
to warm up the grease inside, otherwise hammering function is difficult to get.
8.
Be sure you stand stably and no one is below when you using tool is in high location.
9.
Hold the tool firmly with two hands.
10
. Don't touch any moving parts.
11.
Don't leave the tool running itself, operate tool only when hand-held.
12.
Don't point the tool to anybody for the bit could fly out in case.
13.
Don't touch the BIT OR PARTS CLOSE TO THE BIT immediately after operation, they may
extremely hot and could burn your skin.
14.
Any damage and abnormal happen, please stop to use immediately and disconnect it, ask authorized
serve center to check and repair.
15.
Parts replace:
Only original XINPU's parts can be used to replace by authorized service center.
16.
Right use accessories and parts:
Don't use other parts and accessories which not mentioned in the
manual otherwise may cause injuries!
17.
Special attention to voltage:
Before connect the power tool, please make sure the rated voltage on
the tool can match the power supply, otherwise the power tool may be damaged and cause injuries.
18.
Don't wipe plastic part with solvent:
Solvent such as gasoline, thinner, alcohol etc. these kind of
chemical material, are not allowed to use, water or soap are recommended!
19.
In case of damages the replacement of the plug or the supply cord shall always be carried out by the
manufacturer of the tool or his service organization
20. If the replacement of the supply cord is necessary, this has to be done by the manufacturer or his agent in
order to avoid a safety hazard.
Residual risks
Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the power tool’s construction and design:
1.
Damage to lungs if an effective dust mask is not worn.
2.
Damage to hearing if effective hearing protection is not worn.
3.
Damages to health resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
WARNING!
This power tool produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or fatal injury,
we recommend persons with medical implants to consult their physician and the medical implant
manufacturer before operating this machine.
