10
FS5.8e Elliptical
#115
. M5 x 15mm
Phillips Head Screw
(14 pcs)
#119
. 3.5 x 12mm
Sheet Metal Screw
(8 pcs)
#122
. M6 x 10mm
Phillips Head Screw
(4 pcs)
4
Hardware Step 4
1. Install the two Wheel Covers (
79
-Left &
80
-Right) with four Phillips Head
Screws (
115
).
2. Install the Center Cover (
85
) with four Phillips Head Screw (
115
). You
need to raise the incline to install the Center Cover.
3. Install the Swing Arm End Cap Covers (
81
&
82
-Left,
83
&
84
-Right) with
the eight Sheet Metal Screws (
119
).
4. Install the two ‘Z’ shaped metal brackets (
24
) as shown with four Phillips
Head Screws (
122
). The Z Brackets should be installed so the tab with
the tapped hole is pointing toward the rear.
5. Install the Rear Incline Cover (
87
) with two Phillips Head Screws (
115
).
Install the Rear Stabilizer Cover (
88
) with four Phillips Head Screws
(
115
).
Plastic Covers
Note: Use the Phillips Head Screw Driver (157) to tighten the hardware in this step.
