CUSTOMER SERVICE 1-888-707-1880
19 MAURICE PINCOFFS CANADA©2010
Maintenance Menu in console software:
The console has built in maintenance/diagnostic software. The software will allow you to change the
console settings from English to Metric and turn off the beeping of the speaker when a key is pressed for
example. To enter the Maintenance menu (may be called Engineering mode, depending on version)
press and hold down the Start, Stop and Enter keys. Keep holding the keys down for about 5 seconds
and the message window will display “Engineering mode”. Press the enter button to access the menu
below. Press the up and down keys to navigate the menu.
a.
Key test
(will allow you to test all the keys to make sure they are functioning)
b.
Functions
(Press enter to access settings, use up/down keys to scroll)
i.
ODOMETER reset
(reset the odometer)
ii.
Units
(Set to English or Metric display readings)
iii.
Bike or Elliptical
(changes settings so the console can be used on an Xterra bike or
elliptical)
iv.
Sleep mode
Turns on/off sleep mode.
v.
Motor test
(continually runs the tensioning gear motor)
vi.
Manual
(Allows stepping of the gear motor)
vii.
Key tone
(Turn on or off the beep when a key is pressed)
viii.
Clear EEPROM
for engineering use only
c.
Security
(Allows you to lock the keypad so no unauthorized use is allowed) When the child lock
is enabled, the console will not allow the keypad to operate unless you press and hold the Start
and Enter buttons for 3 seconds to unlock the console.
