26
DNS address: Please use DDNS function to set the DNS address as your local
DNS address.
Note:
After revise and save parameters, the device will restart. If it is applied in LAN,
please pay attention to avoid its IP conflicting with the IP addresses of other devices or
PC in the LAN.
[WiFi settings]
Note:
Apply to models with WiFi function only.
A wireless router needs to be deployed in order to use the WiFi function of IP
camera. Take TP-Link WR340G 54M wireless router as an example. The content and
steps of the settings are as follows:
1. Network parameters setup for wireless router
First enter into the wireless router “network parameter” page under the menu “LAN
Setting” and set the IP of wireless router.
2. Turn to the “basic settings” page under “wireless parameters” menu
(1) Set SSID
This SSID is for identity validation of wireless network. It must be the same as the
SSID setting of the IP camera.
(2) Frequency range
It is determined by the frequency range of the network, which should be 1~13. The
default value is 6.
Note:
If your neighbor also uses wireless network and its frequency is 6, you should
consider revise this parameter to 1 or 13 to reduce the radio interference between the
two routers.
(3) Mode
Set the working mode of wireless router. The mode must be compatible with the
supported modes of IP camera.
Wireless modes supported by IP camera are 802.11b/g protocol (low power WiFi
model) and 802.11a/b/g/n protocol (high power WiFi model).
(4) Enable WiFi function (compulsory)
(5) Open security setting (optional): Enable the security certification of wireless
router. If it is enabled, users need to select the corresponding security mode (encryption
mode) and set up authentication password.
(6) Select security type (encryption mode): WEP, WPA and WPA2
(7) Security options
WEP security type: developing system, sharing key and auto-selection
WPA, WPA2 security type: TKIP and AES
(8) Set key (authentication password)
3. WiFi function settings of IP camera:
(1) Wireless network on/off
