23
detection time, linkage alarm output, alarm output duration, E-mail sending when alarm
is triggered and linkage snapping/recording etc.
[Detection On/Off]: Enable or disable motion detection.
[Sensitivity]: Sensitivity range is 1~5. Greater value means higher sensitivity.
[Detection time setup]: Set the period of time for motion detection. Two periods are
allowed.
[Linkage Alarm output]: Enable or disable linkage alarm output
[Alarm Output Duration]:
Set the duration of the linkage alarm output after being
triggered (in seconds). The range of the duration is 0~86400s. 0 means that there is no
limit for alarm output.
[E-mail sending]: Send video loss detection alarm information to users via E-mail.
Details about E-mail setting please refer to [Network Settings].
[Linkage Snapping]: When alarm is triggered, the device SD card will be driven to
snap pictures. The pictures can be saved via E-mail sending or FTP uploading. For
snapping parameters, if the number of pictures snapped at one time is set as 10 and
the snapping interval is 1 second, then, when there is an alarm, 10 pictures will be
snapped and the interval between each picture is 1 second.
[Linkage recording]: When alarm is triggered, the device SD card will be driven to
record video. The record files can be saved via E-mail sending or FTP uploading.
[Set detective area]: Left click and drive the mouse to set the surveillance areas (4
areas at most).
[All]: Set the whole video as motion detection area.
[Clear]: Clear all motion detection areas.
Click [save] to make the parameters effective after all the settings as above are
done.
2.
Sensor Alarm
See below picture for the interface of IP camera “Sensor Alarm”:
Set sensor alarm parameters here: detection on/off, sensor type, detection time,
linkage alarm output, linkage output duration, E-mail sending when alarm is triggered
and linkage snapping/recording etc.
[Detection On/Off]: Enable or disable sensor alarm detection.
