XtendLan XL-EFM404 G.SHDSL .bis EFM Modem User Manual
V0.01
4.9
Ping
Ping command will be used to test the connection of EFM modem. Please move cursor to
ping and press enter.
----------------------------------------------------------------------
Command: ping <ip> [1~65534|-t] [1~1999]
Message: Please input the following information.
IP address <IP> : 10.0.0.1
Number of ping request packets to send (TAB select): -t
Data size [1~1999]: 32
----------------------------------------------------------------------
There are 3 parameters for ping command:
IP address: The IP address which you want to ping.
Number of ping request packed to send, key TAB for further selection
z
Default: It will send 4 packets only
z
1~65534: Set the number of ping request packets from 1 to 65534
z
-t : It will continuous until you key Ctrl+C to stop
Data Size: From 1 to 1999
4.10 Administration
You can modify the user profile, telnet access, SNMP (Sample Network Management
Protocol) and supervisor information (supervisor password and ID) in admin.
For configuration the parameters, move the cursor “
>> “
to admin and press enter.
>> user
Manage user profile
security Setup
system
security
snmp Configure
SNMP
parameter
passwd
Change supervisor password
id Change
supervisor
ID
User Profile
You can use user command to clear, modify and list the user profile. You can setup at most
five users to access the EFM modem via console port or telnet in user profile table however
users who have the supervisor password can change the configuration of the EFM modem.
Move the cursor “
>> “
to user and press enter key.
>> clear
Clear user profile
modify
Modify the user profile
list List
the
user
profile
You can delete the user by number using clear command. If you do not make sure the
number of user, you can use list command to check it. Modify command is to modify an old
user information or add a new user to user profile.
To modify or add a new user, move the cursor “
>> “
to modify and press enter.
60
