2
XtendLan XL-EFM404 G.SHDSL .bis EFM Modem User Manual
V0.01
Interface number <1~1>: 1
-----------------------------------------------------------------------------
The default interface number is 1, no matter what it the model.
LAN interface parameters can be configured LAN IP address, subnet mask and NAT network
type.
Select link_type item:
>> link_type
Configure Link type
address LAN
address
and
subnet
mask
-----------------------------------------------------------------------------
Command: setup lan 1 link_type <Disable|Dynamic|Static>
Message: Please input the following information.
Link type (TAB Select) <Disable>:
-----------------------------------------------------------------------------
You can select the lan 1 link type is Disable, Dynamic or Static.
Select address item:
link_type Configure
Link
type
>> address
LAN address and subnet mask
-----------------------------------------------------------------------------
Command: setup lan 1 address <ip> <netmask>
Message: Please input the following information.
IP address (ENTER for default) <192.168.2.1>:
Subnet mask (ENTER for default) <255.255.255.0>:
-----------------------------------------------------------------------------
You can configure LAN IP address, subnet mask. The default value is 192.168.2.1 and
255.255.255.0
VLAN
Virtual LAN (VLAN) is defined as a group of devices on one or more LANs that are
configured so that they can communicate as if they were attached to the same wire, when in
fact they are located on a number of different LAN segments. Because VLAN is based on
logical instead of physical connections, it is extremely flexible.
You can setup the Virtual LAN (VLAN) parameters in VLAN command. The EFM modem
support the implementation of VLAN-to-PVC only for bridge mode operation, i.e., the VLAN
spreads over both the CO and CPE sides, where there is no layer 3 routing involved. The
unit supports up to 8 active VLANs with shared VLAN learning (SVL) bridge out of 4096
possible VLANs specified in IEEE 802.1Q.
Move the cursor “
>> “
to vlan and press enter.
>> mode
Trigger virtual LAN function
modify
Modify virtual LAN rule
pvid
Modify port default ID
link_mode
Modify port link type
list Show
VLAN
configuration
53
