15 / 42
3.2.3. WALL MOUNT INSTALLATION
Step 1.
Install the bracket for pendant dome
Pic. 19
When installing outdoors, make sure installation is properly sealed to keep moisture out.
Refer to the instructions supplied with the bracket. Take out cables for the dome through the bracket. See Pic. 19.
Pic. 20
Press the thumb fastener and open the hinged door to the back box. Take out hole of pin. Screw the metal cover into the
bracket. See Pic. 20.
Pic. 21
Connect cables to hole of pin. Insert the pin inside the back box. When finished, close the door to the back box and turn
on the power. The LED will light up. See Pic. 21.
If the LED does not light up, refer to Section 5: Trouble Shooting.
Step 2.
Install dome drive
Pic. 22
Set the DIP switches for SW1 and SW2 at the bottom of the dome drive for the appropriate receiver address,
communication protocol, and baud rate. Refer to the labels on the dome drive or DIP SWITCH SET at the beginning of
this manual.
Remove cover of camera and sponge. See Pic. 22.