3.1.2
Speed Dome Camera Communication Protocol Setting
SW 1 switch:
3.1.3
Speed Dome Camera Transmission Speed Setting (Baud Rate Setting)
The 5th and 6th bits of FUN on the PCB board are used to set the baud rate (see following
figure). The default baud rate setting is 9600.
SW1 switch:
3.1.4
RS-485 Bus Matching Resistance
For central controlling, the matching resistance should be set for the device that is furthest
away from the controller. There is an end matching resistance switch on FUN. The 8
th
bit of
FUN shows ON status (see chart below) which means the BUS matching resistance has
been connected.
Summary of Contents for SDOME4802201
Page 12: ......
