Using the tripod socket : The camera is equipped with a socket at the bottom
end to enable mounting on a tripod or other mounting accessories with a
standard 1/4-20 thread.
Sensing Angle and Distance Test
To test whether the XtendLan Cam can effectively monitor the area you
choose,
this test is recommended to check the sensing angle and monitoring distance
of the XtendLan Cam. To perform the test:
• Switch the XtendLan Cam to the SETUP mode.
• Make movements in front of the camera at several positions within
• the area where you expect the game or subjects to be. Try diferent distances
and angles from the camera.
• If the motion indicator LED light blinks, it indicates that position can be
sensed. If it does not blink, that position is outside of the sensing area. The
results of your testing will help you find the best placement when mounting and
aiming the XtendLan Cam. The height away from the ground for placing the
device should vary with the animal size appropriately. In general, 3 to 6 feet is
preferred.You can avoid potential false triggers due to temperature and motion
disturbances in front of the camera by not aiming it at a heat source or nearby
tree branches or brush (especially on windy days).
Switching ON the Camera
Once you switch to the ON mode, the motion indicator LED (red) will blink for
about 10 seconds. This gives you time to close and lock the front cover of the
XtendLan Cam and then walk away. During this time, the motion indicator
LED will blink red continuously. After it stops blinking, the PIR is active, and
any motion that is detected by it will trigger the capture of photos or videos as
programmed in the SETUP Menu. Be sure you have read the descriptions of
the Capture Number, Video Length, Interval and Sensor Level parameters.
Please note, the sPlR is strongly sensitive to ambient temperature. The greater
the temperature diference between the environment and your subject, the
farther the possible sensing distance. The average sensing distance is about
45 ft.
Before leaving the camera unattended, please check for the following:
• Are the batteries or DC power supply inserted/connected with correct polarity
and is the power level is suicient?
• Does the SD card have sffuicient available space and is its write-protection
(lock) switch off?
• Is the Power switch in the ON position? (do not leave it in SETUP).
PLAYING BACK/DELETING the PHOTOS/VIDEOS
After you have setup, mounted and activated your XtendLan Cam, you will
of
course be eager to return later and review the images it has captured for
you. There are several diferent ways this can be done.
Reviewing Images on the XtendLan Cam LCD (Models with Color
Viewer only)
• Put the power switch in SETUP mode (switch to OFF irst).
• Push the OK(Replay) key to enter image review mode.
• Use the UP/DOWN keys to scroll through your photos or videos. The right
corner of the display will
indicate”JPG”for still photos,and a film icon for video
iles. Press the RIGHT(Shot) key to review a video.
