Iwage Sensor
5Megapixel Color CMOS
Lens
F=2.8;
FOV=40”Auto IR-Cut-Remove(at night)
IR-Flash Range
36'-45'(12m-15m)
Display Screen
1.5 inch Std B&W Display; 2.4 inch Color Display
Memory Card
SD or SDHC Card, Maximum capacity 32GB
Internal RAM
32M
Date/Time Stamp not appearing on images
Make sure that the "Time Stamp" parameter is set to "On"
Photos Do Not Capture Subject of Interest
1. Check the "Sensor Level" (PI R sensitivity) parameter setting.
For. warm environmental conditions, set the Sensor Level to "High"
and for cold weather use, set the sensor for "Low"
2. Try to set your camera up in an area where there is not a heat
source in the camera's line of sight
3. In some cases, setting the camera near water will make the
camera take images with no subject in them. Try aiming the
camera over ground.
4. Try to avoid setting the camera up on small trees that are prone
to being moved by strong winds.
5. Remove any limbs which are right in front of the camera lens.
PIR Sensor LED Flashes/Doesn't Flash
1. When the camera is in the "Setup" mode, a special LED on the
front of the camera will flash when it senses motion. This is for
setup purposes only and will help the user aim the camera.
2. During use, the LED will not flash when the camera takes an
image. This is to help keep the camera hidden from game.
LCD Screen Issues
1. LCD screen powers on but no text is present.
a. After moving the switch from "Off' to "Setup" or "On",makesure
that the switch is correctly in position to ensure the proper mode
(avoid positions "between" two modes).
b. Do not move the switch directly from "On" to "Setup"-always
move the switch all the way down to "Off' first, then back up to
"Setup"
2. LCD screen shows a faint black line after turning from
"Setup" to "On"
a. The LCD will turn off when you slide the switch to the "On"
position. I n some cases, this black line will appear and then fade in
about 1 second. This is normal and the camera will function
properly.
3. Screen comes on but then powers off
a. Make sure that you have installed the SD card correctly.Camera
won!'t retain settings
1. Make sure that you have been saving the changes to any param-
eter settings that you made while in Setup mode, by pressing "OK"
after changing the setting. If you don!-t save your new setting
afterchanging it, the camera will continue to use the original default
setting for that parameter.
TECHNICAL SPECIFICATIONS
