Network Video Recorder User Manual
16
Chapter 5 PTZ Controls
5.1
Configuring PTZ Settings
Follow the procedure to set the parameters for PTZ. The configuring of the PTZ parameters
should be done before you control the PTZ camera.
Steps:
1
）
Enter the PTZ Setting interface,as shown in figure 5.1;
Figure 5.1 PTZ General Setting Interface
2
）
Set the parameter of PTZ
：
（1）
Channel:
Choose the channel.
（2）
Protocol:
Choose the protocol for your PTZ.
（3）
Decoder Address:
Choose the decoder address.
（4）
Baud Rate:
Select the baud rate.
（5）
Data Bit:
Select the data bit.
（6）
Stop Bit:
Select the stop bit.
（7）
Parity:
Select the verify, Non Parity by default.
（8）
Stream Control:
Select the stream control, No Flow Control by default.
3
）
Click
Save
button to save the settings.
5.2
Setting PTZ Preset, Cruise, Pattern&Linear Scan
Before you start:
Please make sure that the preset, cruise and pattern should be supported by PTZ protocols,as
shown in figure 5.2.
