28
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
Step by Step Reassembly – Inspire
2nd Stage
1.
Prepare Crown Orifice (13)
A. Install o-ring (14) on the crown orifice (13).
B. Set aside for the next completed assembly.
2. Build Poppet Valve Assembly
A. Press a new low pressure seat (20) into the end of
the poppet (21)
B. Install 2 each of the small o-rings (22) on the tail
of the poppet (21)
C. Place the spring (23) on to the back of the poppet
(21)
D. Install the flat end of the balancing chamber (24)
into the spring (23). The tail of the poppet (21), with
its two o-rings (22) should be seated inside the
balancing chamber (24).
E. Set aside for the next completed assembly.
NOTE: The latest lp seat is the one that is
orange in color. This is the one found in the service
kit. Please discard previous versions that are colors
other than orange.
3. Prepare Adjusting Knob (26)
A. Install o-ring (25) into groove on the adjusting
knob (26). Set aside for the next completed
assembly.
4. Building the Complete Valve Assembly
A. Install the lever (19)
i. To orient the lever (19) properly, hold the valve
housing (17) with the external threads
to the right. The air outlet hole should be
facing you. Insert the lever feet so that the lever
(19) trails off to the left. See image below.
1B
2A
2B
2C
2D
3A
4A
