21
www.XSscuba.com
XS Scuba Inspire Regulator Service Manual
Inspire 1st Stage Reassembly
1. Mount body (11) in vise.
A. Install the TL122 Support Handle / Vise-Mounting
Tool into one of the HP ports.
B. Mount tool so that the MP diaphragm side of the
body (11) is facing up.
2.
Install the lifter, (12) pin side first, into the
body (11).
3. Install diaphragm (13).
A. Press fit the diaphragm (13) into the under-cut
groove of the main body (11). Work the edges with
your finger to make certain that is fully seated in the
under-cut.
4. Install the diaphragm washer (14) on top of
the diaphragm (13). It, too, should fit in the
under-cut recess.
5. Place the spring seat (15) in the center of
the diaphragm (13) with the perimeter tabs
facing up.
6. Drop a main spring washer (16) on to the
spring seat (15).
7. Set the main spring (17), either end up, on to
spring seat (15).
8. Add the second main spring washer (16) on
top of the main spring (17).
2A
3A
4A
5A
6A
7A
8A
