STEP 5
STEP 4
STEP 1
STEP 2
Remove the wireless
ignition node from the
dashboard. (Disassemble
the dash to access the
ignition barrel)
STEP 8
STEP 6
STEP 7
Slide open the cover of the
wireless ignition node.
Cut the lip off the cover.
Insert the CHWFR circuit
board as shown.
Ensure the
board is well aligned.
CHWFR circuit
Align the
circuit board with the
6 pins on the wireless
ignition node.
CHWFR
Using supplied screw ONLY, apply LOCTITE to
screw and secure* wafer into PCB as per
diagram. Reassemble key module and install
back into the vehicle.
* Be sure not to over tighten the screw as
damage to the factory circuit board may occur.
Use a flat screw driver
to lift out the 2 tabs on
each side of the cover.
STEP 3
Install key interface into wireless ignition node
(-)
/(+)
I/O
STATUS
WIRE
COLOR
SPECIFIC WIRE CONNECTION LOCATION
Connect
Location
Constant (+) 12 Volt Source
Chassis Ground
Legend: RCS = Remote Control System N/C = No Connection N/A = Not Applicable
Blue
Green
Brown
RCS
Orange
Red
Input
Input
(+) Vehicle
Black
Input (-) Vehicle
Pink
P
IN
#
1
2
3
7
8
9
10
(-)
FUNCTIONS
Power Source
Ground Source
C
onnect to (-) When Running (status), output of RCS
Activate the module
.Remote Starter Interface
Input (+) RCS
Connect to Starter wire at Remote Starter or CHWFR
Starter input +
Vehicle
Output
(+)
Connect to PIN 1 at ignition barrel (See FIG.: 2)
Ignition output
RCS
Input (+)
Connect to ignition wire at Remote Starter or CHWFR
Ignition input
Vehicle
Output
(+)
Connect to PIN 2 at ignition barrel (See FIG.: 2)
Accessory output
WIRE GUIDE: CONNECTIONS
Section B
10 PIN HARNESS
Page 5 to 8
Section C
To program the
module, see page 7
MODEL: pkucg2x
Rev.: 20091028
© 2008 Directed Electronics. All rights reserved.
