https://www.XPOtool.com
Item 51537–51541
Page 5
The Tool Experts
08 2022-1
Areas of application
This pump is mainly used as a cellar pump. When placing this into a shaft, the pump provides protection
from flooding. Additionally, the pump can be used, where water needs to be transported from one area
to another, e.g., at home, in agriculture, in gardening, for sanitary work and so forth.
Work settings
After thoroughly reading the operating manual and understanding it, the pump can be put into operation.
Please note the following things in advance:
•
The pump is on the floor of the shaft.
•
Ensure that the pressure line is attached properly.
•
Check if the electrical connection has 230
V and 50
Hz. All fibre particles possibly collected in
the pump casing should be removed with a water stream.
•
Check if the socket is in a good condition.
•
Make sure that water and humidity never reach the main components.
•
Avoid any running dry of the pump.
Maintenance instructions
•
This waste water pump is an approved, maintenance-free, high-quality product subject to a strict
final inspection.
•
We recommend a regular inspection and maintenance to ensure a longer lifespan of the device
and an interruption-free operation.
Important notes!
•
Before every maintenance work, pull out the plug.
•
In case the pump should be transported frequently, it needs to be cleaned with clear water after
every use.
•
When installing the pump stationary, the function of the floater should be checked every
3
months.
•
All fibre particles possibly collected in the pump casing should be removed with a water stream.
•
Every 3
months, the shaft bottom should be freed from mud.
•
Remove the residues on the float switch with clear water.
Cleaning the drive wheel
If there are excessive residues collected in the pump casing, the bottom part of the pump needs to be
demounted the following:
1.
Loosen the 4
screws on the bottom of the inlet cage.
2.
Remove the suction cage from the pump casing.
3.
Clean the drive wheel with clear water.
Important!
The pump must not be placed on the drive wheel.
4.
Build the pump back together in the reversed order.
