7
FAN
WALL
WALL
Transformer
Note: This part must not be mounted
in the interior of a bath tub or
shower basin and must be
positioned out of reach of a person
using a fixed bath or shower. It
should be also positioned away from
any source of water spray.
Location of the Transformer Unit
1.
Check that the electrical rating shown on the inside of the product matches the main supply
2.
Check there are no buried pipes or cables e.g. Electricity, gas, water behind the switch location
(in wall or above the ceiling)
3.
Isolate the mains supply
The Transformer may be mounted on the wall or ceiling.
Position the transformer/humidity unit at least 6” (150mm) from a corner to allow correct airflow over the
humidity sensor. Also, ensure the humidity sensor unit is not directly in the stream of the fresh air coming in from
the fan unit, as this will result in false sensing.
An ideal location is on the same wall, or one immediately adjacent which is in the stream of the stale/damp air
being drawn into the side vents of the fan assembly.
Wiring
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN
For fixed wiring circuits the protective fuse for the appliance must not exceed 3A.
◆
A double isolating switch with a minimum contact gap of 3mm (wall or ceiling mounted).
◆
If metal switch boxes are used, earthing regulations must be following.
◆
Suitably rated 2 core cable.
◆
3 mm electricians screwdriver and No.1 or No 2 pozidrive screwdrivers.
◆
Masonry drill, hammer & chisel (or core drill equipment if available)
◆
Mortar to make good the hole if required
Decide how you are going to run the wires from the transformer to the fan unit. “All wiring must be in accordance
with IEE wiring regulations”.
A 5 amp two core power cable is required to connect the fan assembly to the remote control.
A two core, 3 amp supply is required on the input mains connection. An earth connection is not required.
Pass the input and output wires through the cable hole in the base plate of the remote control and fasten it in
position.
(SEE DIAGRAM ON PAGE 2)
To comply with electrical safety regulations both input and output leads must be clamped to the unit using the
saddle clamps provided.
m)
Mains wiring for remote control and transformer:
Red or Brown wire
to live terminal
Black or Blue wire
to neutral terminal
Do not apply power to the transformer yet.
No earth is required to the ventilator in accordance with IEE wiring regulations for SELV circuits.
All wiring must be 1mm minimum, fixing securely to comply with IEE wiring regulations, if in doubt consult a
qualified electrician.
Eclipse - Oxplaire 12/4/00 6:51 pm Page 7
