18
Remote Sense
OFF
Rotating either control will alternate between the ON or OFF selection. Press the Output On/Off button when the desired mode
is displayed.
Short load end
of load wires
Adjust to Normal
current
I=2.33
If the NO option is selected the system will revert to the Setup main menu. If the YES option is selected the following screen will
be displayed:
At this point the load end of the wires must be shorted as shown below:
It is important that a good short with heavy wire is made as failure to do this will result in a poor remote sense calibration.
Once the short is in place, press the output on/off button. The following screen is an example of what will be displayed.
Load
Short here
