Xmart OPTIMA RT9W 1K, User Manual

Page: 6 / 28

INDEX
USER MANUAL - OPTIMA RT9W 1K/2K/3K
www.xmart-ups.com
VER.171130-WP+-ENG
6
AC CONNECTIONS
Install this UPS indoors with a conditioned temperature free of dust. The site conditions must comply with room specifications required in
the specifications table of this manual.
Plug UPS input power-cord to the wall socket with rated voltage according to your UPS model.
Connect your products to UPS outlets without overloading UPS. Total power required to the UPS must be below maximum UPS capacity.
We suggest to use this UPS below 75% of its maximum power.
Load products like laser printers, Xerox copiers or scanners requires high peak power that can overload this UPS. User must size UPS to
maximum power required by load.
IMPORTANT: Do not connect loads based on AC motor or high inductive loads like transformers. This kind of
loads can generate UPS error states.
Most of models come with input power-cord with a plug according to your country. However, some 3KVA models in 120V could be
equipped with input terminal block. User must connect line, neutral and ground to input terminal block using cables with required gauge
to drive maximum rated current. For 3KVA UPS in 120V, wires must be minimum 12AWG (for lengths shorter than 15m – 50 feet). Wiring
gauge is conditioned to length, temperature, etc. Wiring must be selected by professional according to local electrical regulations.
EXTERNAL BATTERIES (XBAT)
Additional external Battery modules can be connected to this UPS to have longer runtime. External batteries are optional for long run
applications. XBAT must be connected by using original DC cables included inside XBAT box. XBAT must be connected to the DC connector
located on rear panel of the UPS.
IMPORTANT: There could be OPTIMA RT9W models with different DC voltage that described on this manual. User must always
double check the DC voltage printed on the rear panel of the UPS to confirm it marches with DC voltage provided by XBAT.
RT9W 1K: 24VDC RT9W 2K: 48VDC RT9W 3K: 72VDC
1) Place UPS module close to original XMART XBAT modules.
2) Check all DC switches on XBAT are in OFF position.
3) Connect UPS to first XBAT module by using original DC cable
4) In case system has more than 1 XBAT, connect XBAT#1 to XBAT#2. Then XBAT# 2 to XBAT#3 and so on.