XR Series Wireless Arrays
6
Twist the four T-bar clips onto the metal ceiling grid at the
marked locations and tighten the screw posts to 10-12 lbf.ft
(1.38-1.66 kgf.m). Do not over tighten the screw posts.
5.
Cut an access hole for the cable(s) in the ceiling tile and draw
the cable(s) through.
6.
Align the XR-600 mounting plate over the screw posts of the
T-Bar clips or bracket and secure it to the four posts using the
nuts provided. Tighten the nuts to 10-12 lbf.ft (1.38-1.66
kgf.m), but do not over tighten.
7.
Align the two slots in the back of the XR-600 chassis shown at
right…
8.
… with the corresponding tabs in the XR-600 mounting plate
shown here.
9.
Push the XR-600 chassis up on the mounting plate tabs and
rotate the XR-600 to the right until it snaps in place.
10.
To secure the XR-600 to the mounting plate, feed a zip tie
through the hole in the top of the locking slug and the
matching hole in the ceiling mounting plate.
11.
Proceed to
