V5 series inverter
95
7
777 Communication
Communication
Communication
Communication P
P
P
Protocol
rotocol
rotocol
rotocol
7-1.
7-1.
7-1.
7-1. O
O
O
Overview
verview
verview
verview of
of
of
of communication
communication
communication
communication protocol
protocol
protocol
protocol
These series inverter supply RS485 communication port and adopt MODBUS startded communication protocol. Therefore,
the inverter can be set as a slave to communicate with the marter (such as PLC and PC) which has the same communicatin
port and protocol; also, user can use a inverter as the master to communicate with several inverters produced by our
company via RS485 port to realize multi-machine linkage. Besides, you can connect the RS485 port to remote keyboard to
realize remote operation.
This inverter support MODBUS-RTU, the following is the particular instruction for the inverter’s communication protocol
.
7-2.
7-2.
7-2.
7-2. Instruction
Instruction
Instruction
Instruction of
of
of
of communication
communication
communication
communication protocal
protocal
protocal
protocal
7-2-1
7-2-1
7-2-1
7-2-1.... Communicating
Communicating
Communicating
Communicating mode
mode
mode
mode
Inverter
Inverter
Inverter
Inverter as
as
as
as a
a
a
a slave
slave
slave
slave
Fig.
Fig.
Fig.
Fig.7
7
7
7
－
1
1
1
1
Networking
Networking
Networking
Networking diagram
diagram
diagram
diagram of
of
of
of inverter
inverter
inverter
inverter
Multi-device
Multi-device
Multi-device
Multi-device linkage
linkage
linkage
linkage
Fig
Fig
Fig
Fig 7
7
7
7----2
2
2
2 Networking
Networking
Networking
Networking diagram
diagram
diagram
diagram of
of
of
of multi-device
multi-device
multi-device
multi-device linkage
linkage
linkage
linkage
7-2-
7-2-
7-2-
7-2-2
2
2
2.... Communication
Communication
Communication
Communication modes
modes
modes
modes
The inverter can be used as both master and slave in RS485 net. If it is used as a master, it can control other inverters made
by our company to realize multi-machine linkage.If it is used as a slave, PC or PLC can be set as a master to control it. The
concrete communication modes are shown below:
(1) (1) The inverter is a slave in the network. It communicates in ‘point to point’ mode. The inverter will not response
to the command sent by the master via broadcast address.
Summary of Contents for V5-4011
Page 59: ...V5 series inverter 53 ...
