Use only Xingyi parts and accessories, For your own safety, The Safety of others and the life of your machines.
8
reverse switch to start the machine.
12
．
Note that the emergency stop switch can only be pressed or rotated, NEVER PULL
THE SWITCH UPWARD!
13
．
Check the ground area before the machine work, remove any hard objects such
as bolts and nails that could cause machine damage.
14
．
When inserting the power supply, must make sure the working voltage of the
machine, the frequency are the same as the input voltage and frequency, and the input
power has no phase loss. (If the input power is not in accord with power when the work
normally, resulting in damage to the machine, out of warranty).
15
．
Install the appropriate vacuum cleaner on the suction pipe connection to facilitate
dust-free operation.
16
．
If the machine is always running in a certain direction, adjust the height of the
wheel shaft to the best position (may be adjusted upward or downward), and ensure the
heads are parallel of the wheel shaft and the ground.
17
．
Install the appropriate abrasive. Improper abrasive may cause personal injury and
floor damage.
18
．
After installing the abrasive, contact the grinding disc with the ground. The
adjustment level should be adjusted to the "upright position". The operator can operate
comfortably.
19
．
The inverter jumps "overload protection" to indicate that the machine has a
problem (the power wire specification is too small, or the voltage is unstable.) Please refer
to the recommended power wire specifications below. Or reduce the grinding pressure
(without adding iron). (Other losses caused by continuous use of the machine during
overloading are not warranted.).
20
．
After grinding for several minutes, stop the machine to check the wear level of
abrasives. This can effectively save economic losses due to the use of the wrong abrasives.
21
．
Do not tilt the machine while the machine is still running, otherwise the abrasive
will fly off and it will cause a personal threat.
22
．
During operation, if the grinding disc falls off, please stop the machine immediately,
otherwise it will cause damage to the machine or personal safety.