14
15
Use
This Bidet may lightly move because being installed in the sliding one-touch
installation method, which is not abormal.
Caution : The distance between the back side of Bidet and water tank of toilet seat shall be within 10mm.
Note
The adjustment allowance of Mounting Plate position is 140~200mm along sideways
and 40mm back and forth.
Note
3. Connection of Hoses and installation of Main Body
1. Preparation
Close the water supply valve connected to
the water tank of the product.
Remove the existing toilet seat by loosening
the bolts at the bottom.
Store the removed seat.
Place the Mounting Plate on the toilet.
Align the holes in the mounting plate with the holes
in the toilet and insert the fastening bolts with bolt
stoppers from above.
Check if the existing water valve is properly
closed and detach the water tank hose of the
toilet from the existing water tap.
Connect the T-Valve to the water tap (Insert
rubber stopper)
Connect the detached water tank hose of the
toilet to the T-Valve.
Fasten the semi-sphere Stoppers and
fastening nuts as shown in the picture.
2. Installation of the Mounting Plate
Push the main body into the mounting plate till it
clicks.
Connect Bidet hose to the main body.
(Check rubber packing)
Open the valve of water supply
Water Leakage Check
Before connecting the power, open the water valve and see carefully
if there is any leakage of water.
4. Power Connection and Water Valve Test
Before Test Operation
DEODORIZATION Check (PB-X1500, PB-X2500)
Check if air blows out from the right side back of the Main Body
CLEANING and BIDET Functions Check
Press WASH OR LADY WASH button
Check if water flows out of the nozzle after 1~2 minutes.
Check if there is any leakage of water from the Main Body.
Press the WATER PRESSURE button and check if the
strength of water spray responds.
Check if the temperature of the water from the nozzle
is appropriate. (by feeling the water with hand lightly
touching the nozzle end)
Check if operation stops by pressing the STOP button.
DRY Function Check (Except PB-X800, PB-X1200)
Check if warm air blows out from right side of the nozzle by
pressing the DRYER button.
Check if operation stops by pressing the STOP button.
5. Test Operation
As this Bidet uses a water storage tank, pressing the CLEANSING button for the first
time after the installation will cause delay of 1~2 minutes until the water fills the water
tank and flows out through the nozzle.
Summary of Contents for PB-X1000
Page 1: ...4224 0048 00 Rev 00...
Page 12: ......