Xime PB-X1000, User Manual

Page: 9 / 12

16
Use
17
WASH Operation (for Anal Cleaning)
1. Press WASH button while sitting on the toilet seat.
The Cleansing Lamp lights up and spray of water jet begins.
Operation lasts for 2 minutes.
Position the nozzle using the NOZZLE POSITION buttons
Adjust the water strength using the WATER PRESSURE
buttons.
Water temperature will drop from the selected temperature
after about 30 seconds and will reach ambient temperature
after about 40 seconds from operation but it is normal.
2. Press MOVE button
Cleansing continues while the nozzle moves back and forth.
The nozzle movement will last throughout the duration of
Cleansing operation.
Position the nozzle using the backward and forward
adjustment buttons.
3. Press DRY button (Except PB-x800, PB-X1200)
Drying is quicker if you wipe the wet area lightly with
toilet paper before using this function.
Operation lasts for 3 minutes.
4. Press STOP button
All functions have set duration of operation but pressing
the START button in the middle of use will stop all the
functions immediately.
Auto-Cleaning (Except PB-X800)
After sitting on the seat, press “Wash” button two times.
The Auto-cleaning lamp lights up (green) and spray water for 1 minute.
After cleaning, start dry function in the level of middle for 2 minutes.
Position the nozzle position button.
Adjust the water strenght using the Water Pressure button.
Water temperature will drop from the selected temperature after about 30~40 seconds.
You can start / stop the seat sensor function. : Press “Seat Temp” button for 3 seconds.
Wind Low Mid High Off
LADY WASH Operation (Bidet)
1. Press LADY WASH button while sitting on the toilet seat.
The Lamp lights up and spray of water jet begins.
Operation lasts for 2 minutes.
Position the nozzle using the NOZZLE POSITION buttons
Adjust the water strength using the WATER PRESSURE
buttons
Water stream is softer and sprays wider area
Water temperature will drop from the selected temperature
after about 30 seconds and will reach ambient temperature
after about 40 seconds from operation but it is normal.
(Since BIDET operation uses more water than Cleansing
operation, the duration of warm water flow may be shorter)
2. Press MOVE button
Cleaning continues while the nozzle moves back
and forth.
The nozzle movement will last throughout the duration
of Bidet operation.
Position the nozzle using the backward and forward
adjustment buttons.
3. Press DRYER button (Except PB-X800, PB-X1200)
Drying is quicker if you wipe the wet area lightly with
toilet paper before using this function
Operation lasts for 3 minutes.
4. Press STOP button
All functions have set duration of operation but
pressing the START button in the middle of use will
stop all the functions immediately.
Wind Low Mid High Off