Wireless
Curtain PIR
sensor
11~20
4
1) Same as above
2) Trigger the PIR sensor by
pressing ”Learning Emitting Switch” on
the panel twice successively
Same as above
Wireless
Indoor siren
N/A
——
1) After connecting to the power, press
the “learning switch on the side of the
siren
2) Press“ ” key on the alarm host, then
disarm b keypad on the alarm host
3) Light on the siren flashes 5 times and
then off indicates successful activating
After connecting to the power, keep
pressing the “Learning” switch on the
side of the siren for 5 seconds and
release, light on the siren flashes 2
times and then off indicate successful
deavtivating
Optional
Accessories
Wireless
Gas alarm
02~10
4
1) Same as above
2)
Trigger wireless gas alarm by
releasing smoke, the host LCD will
display “Success”
Same as above
Wireless
Smoke
Sensor
02~10
4
1)
Same as above
2)
Press any key on the remote
controller twice successively, the
host LCD will display ”success”
Same as above
Remote
Keypad
00
、
01
8
1)
Same as above
2)
Press any key on the remote
controller twice successively, the
host LCD will display ”success”
Same as above
Wireless
Outdoor
Siren
N/A
——
Same as wireless indoor siren
Same as wireless indoor siren
Common Problems and Solutions
Symptoms of Faults
Possible Cause
Solution
The alarm host goes off
immediately after connected to
the power
The telephone incoming line has
not been connected or not well
connected.
Connect the telephone incoming line well.
The alarm host can’t
automatically record or can’t
record completely
The record switch is not on;
The Record key is being pressed
while recording
1.
Slide the record switch to “ON”;
2.
Keep pressing the RECORD key while recording.
Repeatedly receiving the alarm
telephone
Fail to operate according to the
operation
instruction
of
the
telephone alarm
Follow the below instructions after answering the alarm
phone calls and hearing the recorded message:
(See 2.5 Operation ---
Telephone alarm
)
The host does not alarm after
the detector is triggered in arm
state
1. Caused by the functions of arm
mode (Armed Away and Armed
Home);
2. Have already setup time for Entry
Delay or Exit Delay
1.“Armed Away” mode: the alarm goes off when any
sensor is triggered;
2. “Armed Home” mode: the alarm goes off when any
sensor in 1
st
Defense Line is triggered and it won’t
alarm when any sensor in 2
st
Defense Line is triggered
3. Program to adjust the time for Entry Delay or Exit Delay
The PIR sensor doesn’t work
1. Not connected to the power
2. Port of the detector is in the
power-down mode.
1.
Open the sensor shells to install the batteries well
and slide the power switch to “On”;
2.
“5S”: detect once every 5 seconds;
“5MIN”: detect once every 5 minutes;
The detecting distance of PIR
sensor gets shorter
The ambient temperature in the
detecting area is too high.
When the ambient temperature in the detecting area
exceeds the human body temperature, the detecting
distance will get shorter, it’s normal.
The host does not alarm after
the new added wireless detector
is triggered.
Failed to follow the operation
instruction of “Adding and deleting
sensors” to add the new wireless
sensor
Follow the operation instruction of “How to program” to
activate the new wireless sensor
The
PIR
sensor
flashes
frequently in green.
Batteries are running out.
Replace with new batteries of the same specification.
The door magnetic sensor
indicator flashes frequently in
green after alarming.
Batteries are running out.
Replace with new batteries in the same specification.
The distance of the remote
controller gets shorter.
Batteries are running out.
Replace with new batteries in the same specification.
