Xilin CDDR, Operation Manual

Page: 20 / 60

16
Notice
Please check the following items before operation of the stacker:
Ensure no goods falling and goods damaged at loading and unloading area.
Ensure no goods or objects impeding for safety.
As indicated in Fig. II, pull out the general power supply switch, unlock the electric door lock, and drive
the stacker to the goods pile nearby. (The tip of the fork is 300mm from the goods pile). Press the
lowering button, adjust the height of the fork to a proper position, and insert the fork slowly and as deep
as possible into the pallet of the goods. Press the lifting button till the fork is 200-300mm from the ground.
Drive the stacker to the location of the goods shelf and stop slowly. (The tip of the fork is 300mm from the
goods shelf.) Press the lifting button and the fork rises to a proper height with the shelf (The bottom of
the pallet is about 100mm higher than the goods shelf). Move the goods slowly to the accurate position of
the shelf and press the lowering button to put the goods carefully on the shelf. Take the fork away from
the goods and drive the stacker slowly to make the fork out of the goods pallet. (The tip of the fork is
300mm from the goods shelf.) Lower the fork until it is 300mm from the ground and drive the stacker
away from the shelf. Attention should be paid to that there should be no obstacles around and when
turning, the speed should be reduced.
Caution
The driving mechanism of truck is installed on the foreside. Due to this
difference from common vehicles, the foreside of truck swings comparatively fast
when turning around. For this reason, to prevent collision with other objects nearby
the foreside of truck, do drive or turn slowly.
5
．
2
．
5 Operation of taking goods off the goods shelves
：
As indicated in Fig. II, pull out the general power supply switch, unlock the electric door lock, and drive the
stacker to the goods shelf nearby. (The tip of the fork is 300mm from the goods shelf). Press the lowering
button, adjust the height of the fork to a proper position, and insert the fork slowly and as deep as possible
into the pallet of the goods. Press the lifting button to lift the goods till the bottom of the pallet is 100mm
from the goods shelf. Slowly drive the stacker and slowly move the goods out of the shelf (the tip of the
fork is 300mm from the goods shelf). Press the lowering button and the fork lowers to a height of
200-300mm from the ground. Drive the stacker away from the goods shelf until it reaches a desired
position and then slowly stop it. Press the lowering button to put down the goods, make the fork
completely away from the goods and move the fork slowly out of the goods pallet.
5
． ． ． ．
3 Abnormal situation handling during operation
： ： ： ：
5
．
3
．
1When pressing the lifting button, the fork can rise but when releasing the lifting button, the fork is
still rising. The stacker is in a situation of out of lifting control. In that case, turn off the general power
supply switch to cut off the power supply at once. Drive the stacker to a safe position to lower the fork
manually and repair the circuit of the stacker.
5
．
3
．
2 If the brake is out of function when the stacker is in operation, the operation must be stopped at
once and repair the stacker.