Tool
Type
Quantity
Description
Serial port
RJ45
1
Default operating system serial
port used for debugging. You
can also set it as the iBMC
serial port by using the iBMC
command.
NOTE
The port uses 3-wire serial
communication interface, and the
default baud rate is 115,200 bit/s.
Management
network port
1000BASE-T
1
Used for server management.
NOTE
● The management network port
is a GE port that supports 100
Mbit/s and 1000 Mbit/s auto-
negotiation.
USB port
USB 3.0
2
Used to connect to a USB
device.
NOTICE
Before connecting an external
USB device, check that the USB
device functions properly. The
server may operate abnormally if
an abnormal USB device is
connected.
PSU socket
-
2
Used to connect to the power
distribution unit (PDU) in the
cabinet. You can select the
number of power supply units
(PSUs) as required.
NOTE
● When determining the quantity
of PSUs, ensure that the rated
power of the PSUs is greater
than that of the server.
● If only one PSU is used,
Predicted PSU Status
cannot
be set to
Active/Standby
on
the iBMC WebUI.
5.3 Processor
●
The server supports two or four processors.
●
If two processors are required, install them in sockets
CPU1
and
CPU2
.
●
The same model of processors must be used in a server.
●
Contact your local sales representative or use the
determine the components to be used.
FusionServer 2488 V5 Server
Technical White Paper
5 Hardware Description
Issue 06 (2023-12-12)
Copyright © xFusion Digital Technologies Co., Ltd.
19
