XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM CONTROL... User Manual Download Page 27

Page: 27 / 28

XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000501 Rev 2 • Page 27 of 28

XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANEL

CFP USER MANUAL • Approved Document No. DFU7001000 Rev 4

CFP 2/4/8 ZONE FIRE ALARM PANEL

Address:

_________________________________________________________________________

I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the installation of

the fire alarm system, particulars of which are set out below, CERTIFY that the said installation for which I/we have

been responsible complies to the best of my/our knowledge and belief with the specification described below and

with the recommendations of Section 4 of BS5839-1: 2002, except for the variations, if any, stated in this certificate.

Name (in block letters):

____________________________________________________________

Position (in block letters):

____________________________________________________________

Signature:

____________________________________________________________

Date:

____________________________________________________________

For and on behalf of:

____________________________________________________________

Address & postcode:

____________________________________________________________

The extent of the liability of the signatory is limited to the system described below.

Extent of installation work covered by this certificate:

______________________________________________________________________________________

Specification against which the system was installed:

______________________________________________________________________________________

Variations from the specification and/or Section 4 of BS5839-1:2002 (see BS5839-1:2002, Clause 7):

______________________________________________________________________________________

Wiring has been tested in accordance with the recommendations of Clause 38 of BS5839-1: 2002.

Test results have been recorded and provided to: _____________________________________________

Unless supplied by others, the “as fitted” drawings have been supplied to the person responsible for

commissioning the system (see 36.2m) of BS5839-1: 2002: ____________________________________

BS5839-1:2002 recommends that certificates be issued for all aspects of the fire alarm system including design,

installation, commissioning, acceptance, verification (optional) and maintenance. Therefore, before this user

manual is handed over, the following installation certificate and the commissioning certificate (overleaf) should be

completed as appropriate by the relevant installation/commissioning engineer(s). Please ensure that the system set-up

data chart on page 13 and the relevant parts of the system Log Book on page 14 are also completed as appropriate.

For countries outside the UK, different certification requirements may apply.

for the fire alarm system at:

Certificate

of INSTALLATION

BS5839-1:2002 recommends that certificates be issued for all aspects of the fire alarm system including design,
installation, commissioning, acceptance, verification (optional) and maintenance. Therefore, before this user
manual is handed over, the following installation certificate and the commissioning certificate (overleaf) should be
completed as appropriate by the relevant installation/commissioning engineer(s). Please ensure that the system
set-up data chart on page 20 and the relevant parts of the system Log Book on page 21 are also completed as
appropriate. For countries outside the UK, different certification requirements may apply.