Safety notes
Operator Guide
2-12
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX
Printer or controller - emergency power off
If any of the following conditions occur, turn off the equipment
immediately and disconnect the power cable from the electrical
outlet. Contact an authorized Xerox Service Representative to
correct the problem:
•
The equipment emits unusual odors, or makes unusual
noises.
•
The power cable is damaged or frayed.
•
A wall panel circuit breaker, fuse, or other safety device has
been tripped.
•
Liquid is spilled into the equipment.
•
The equipment is exposed to water damage or flood.
•
Any part of the equipment is physically damaged.
NOTE: The only method to remove all power from the printer is
to disconnect the power cable from the electrical outlet.
Printer - ozone information
This product produces ozone during normal operation. The
ozone produced is dependent on print volume and is heavier
than air. Install the system in a well ventilated room with the
minimum cubic size requirements listed below. Providing the
correct environmental parameters will ensure that the
concentration levels meet safe limits.
The minimum cubic volume requirement is: 1,765 cubic feet (50
cubic meters).
To determine if the room has the required volume to meet the
ozone requirement, the length of the room multiplied by its width
and height should be equal to or greater than the cubic volume
listed above.
If you need additional information about ozone, please request
the Xerox publication Ozone (part number 610P64653) by calling
1-800-828-6571 in the United States and Canada. In Xerox
Europe countries and DMO, call the local welcome centre.
Summary of Contents for WorkCentre Pro 75
Page 6: ...TABLE OF CONTENTS iv OPERATOR GUIDE...
Page 28: ...Safety notes Operator Guide 2 16 DocuTech DocuPrint 75 90 and DocuPrint 75 MX...
Page 42: ...Product overview Operator Guide 3 14 DocuTech DocuPrint 75 90 and DocuPrint 75 MX...
Page 76: ...Problem solving Operator Guide 6 6 DocuTech DocuPrint 75 90 and DocuPrint 75 MX...
