Regulatory Information
Xerox
®
WorkCentre
®
EC7836/EC7856 Color Multifunction Printer 291
User Guide
Environmental Benefits of Duplex Printing
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you to
print on both sides of the paper automatically, and therefore helps to reduce the use of valuable resources
by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires that on models
greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome the duplex function
has been auto enabled, during the setup and driver installation. Some Xerox models below these speed
bands may also be enabled with 2-sided printing settings defaulted on at the time of install. Continuing to
use the duplex function will reduce the environmental impact of your work. However, should you require
simplex/1-sided printing, you may change the print settings in the print driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper (60
g/m²), which contains less raw material and thus save resources per print, may be used in certain
applications. We encourage you to check if this is suitable for your printing needs.
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device is
designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print, the
device transitions to Ready mode. In this mode, the device can print again immediately. If the device is not
used for a specified period, the device transitions to Low Power mode, then to Sleep mode. In these
modes, to enable reduced-power consumption, only essential functions remain active. The device takes
longer to produce the first print after it exits the Power Saver modes than it takes to print in Ready mode.
This delay is the result of the system waking up and is typical of most imaging devices on the market.
To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is enabled,
you can configure the mode as follows:
•
Always Allowed
: The device powers off automatically after the specified time, and the cumulative Low
Power mode and Sleep mode timeouts have elapsed.
•
Allowed ONLY When Conditions are Met
: The device automatically powers off only after timeouts
have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired Network have
not been activated.
To change the Power Saver settings, refer to the
User Guide
www.xerox.com/office/EC78XXdocs
For further assistance, contact your System Administrator or refer to the
System Administrator Guide
.
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the
System
Administrator Guide
www.xerox.com/office/EC78XXdocs
To learn more about Xerox participation in sustainability initiatives, go to:
