Xerox WorkCentre 3025BI, Service Manual

Page: 34 / 156

June 2014
2-12
Xerox® WorkCentre® 3025 Multifunction Printer Service Manual
14-100 , 17-100
Status Indicator RAPs
14-100 Document Scanner Assembly Locked Fault
The Document Scanner Assembly does not move.
BSD-Reference:
BSD 14.1 Scanning
Initial Actions
Switch Off the power then switch On the power. (The Contact Image Sensor should move dur-
ing start up.)
Procedure
Check the Scanner Cable to make sure it is securely connected.
The scanner cable is con-
nected.
Y N
• Check that the connectors are secure and no contamination is present
• disconnect and securely reconnect the Scanner Cable.
Enter Diagnostic (EDC) Mode. Select
[DC330, Component Control, 100 Scanner Drive
Motor]
to test the Scanner Drive Motor.
The Motor runs.
Y N
Check the connectors between the Scan Motor and the Control PWB.
The connections
are secure.
Y N
• Check that no contamination is present.
• Disconnect and securely reconnect the connector
Replace the Scanner Drive Motor ( REP 1.11 ), PL 4.1 and PL 4.2 .
If the problem continues, replace the Main PWB ( REP 1.8 ), PL 1.1 .
17-100 IP Conflict Error Fault
The IP address conflicts with that of another system causing a machine communication error.
BSD-Reference:
None
Procedure
Use Xerox Easy Print Manger to obtain a new IP address.
From the menu, select: [
Machine Settings, Network Settings, Assign IP address
].