9. With both hands grasp each side of the Scanner Lid and lower it while depressing
the lid latches on the underside of either end. Ensure that each side clicks into the
locked position by pressing firmly on both ends.
10. Replace the Power Cord to restore power to the scanner.
11. Press the On/Off switch behind the scanner to turn it to the On position.
Note
Ensure the areas are fully dry before scanning.
Scanner Setup
Normalization
The Contact Image Sensor (CIS) can be sensitive to variations in room temperature. For
best results, the scanner should be normalized on a regular basis. Normalization should
be performed whenever image uniformity is visibly changing across the sensor boundaries.
This can happen when the scanner is first installed or if the scanner is exposed to a
temperature change. The scanner should also be normalized after cleaning it according
to the scanner maintenance procedure. (Refer to
Cleaning the Scanner
.)
For detailed normalization instructions, see the documentation for the software that
controls the scanner. Generally a System Administrator performs this task. The calibration
target that came with the scanner is used to perform normalization.
2-5
Xerox
®
Wide Format 7742 Scan Solution
User Guide
Maintenance
