Xerox Phaser 7300B, Service Manual, Page: 51 / 277

Error Messages and Codes 2-35
ATS Gauge Calibration - Verifies ATS Calibration. FOR ENGINEERING USE ONLY.
Edit Gauge
Data Enter Thickness: nn Microns <Press Down for more data>
<Press Info for help>
<Press Back or Cancel to exit>
Execute Gauge
Measurement Insert thickness gauge, then press OK
Test Fault - try again!
Gauge Calibration Passed / Failed
You may need to cycle power
<Press Back or Cancel to abort>
Gauge Measurement Results
Cal. Result: Passed / Non-Paper ADC
Error / Thickness Error / Slant Error /
Sensor ADC Error / Sensor Failure /
Unknown <Press Down for more data>
<Press Info for help>
<Press Back or Cancel to exit>
Calc. Values: (mV/um)
1=n.n 2=n.n 3=n.n AVE=n.n
<Press
Down for more data>
Where 1.40mV/micron is the
standard sensivity value.
<Press
Info for help>
<Press Back or Cancel to exit>
No Paper Samples: 1=nnV, 2=nnV,
3=nnV, CHK=nnV
Paper Samples: 1=nnV, 2=nnV,
3=nnV, CHK=nnV,
<Press
Down for more data>
Measured samples without and
with media present in sensor.
No-Paper Samples = 3.33V.
<Press
Info to toggle display>
<Press Back or Cancel to exit>
No Paper Average: 1=nnV, 2=nnV,
3=nnV, CHK=nnV
Paper Average: 1=nnV, 2=nnV,
3=nnH, CHK=nnV
<Press
Down for more data>
Measured averages without and
with media present in sensor.
No-Paper Average = 3.33V
<Press
Info to toggle display>
<Press Back or Cancel to exit>
ATS Anvil Adjustment - Adjust anvil and read media voltage. See “Automatic Thickness
Sensor (ATS) Calibration Procedure” on page 4-118 for procedures on adjusting the ATS
Anvil.
Anvil Measure: V=n.nn
FOR ENGINEERING USE ONLY <Press OK to repeat test>
<Press Cancel to exit>
NVRAM Access
- This menu lets you read, set or reset selected NVRAM address
locations.
PostScript
NVRAM Reset
PostScript will now reset NVRAM
Are you sure?
Yes
No
Exiting Service Diagnostics Restores the printers setup values
to their factory defaults. For more
information on resetting NVRAM,
See “PostScript NVRAM Resets”
on page 4-122.
CRU Counter
Read Total Pages = nnn
Fuser pages = nnn
Trans.Belt Images = nnn <Press Down for more data>
Service Diagnostics Tests and Functions Table (cont'd.)
Menu Item Front Panel Display Results Functional Definition