6/98
Offset Catch Tray (OCT) Option
9-20
Xerox DocuPrint N17 Service Manual
9.3.13 Drive Motor Assembly/Middle Roll Assembly
Removal
1 Remove the Exit Chute Assembly (
REP 9.3.4 Exit Chute Assembly).
2 Remove the OCT PWB Assembly (
NOTE: At this time, J210 is removed.
3 Remove the one screw that secures the Holder.
4 Remove the one screw that secures the Drive Motor Assembly and the H Earth Plate.
5 Remove the Holder together with the Earth Plate from the Gear Housing (1 in Figure 9.3.13.1).
6 Remove the one screw which secures the Earth Plate to the Holder.
7 Remove the Earth Plate from the Holder.
8 Hold the Drive Motor Assembly and remove the one screw which secures the Drive Motor
Assembly and OCT Wire Assembly.
9 Pull off the Drive Motor Assembly (2 in Figure 9.3.13.1).
10 Release the latch of the Exit Bearing of the Middle Roll Assembly and detach the Exit Bearing (3
11 Pull the right end of the Middle Roll Assembly towards you about 3 cm (4 in Figure 9.3.13.1);
release the latch of the left Exit Gear while holding the Middle Roll Assembly at the position (6 in
Figure 9.3.13.1); and pull off the Roll Assembly towards the right (5 in Figure 9.3.13.1).
12 Detach the left Exit Bearing from the Gear Housing (7 in Figure 9.3.13.1).
Figure 9.3.13.1 Removing the Drive Motor Assembly/Middle Roll Assembly
SAS4AEFA
J210
1
2
3
4
5
6
7
www.printcopy.info
www.printcopy.info
