Xerox DocuPrint 180, System Generation Manual

Page: 31 / 94

SYSGEN AND SYSGEN-RELATED PROCEDURES
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE 4-3
Installing or upgrading System UI dialog
Use the information given below when installing or upgrading System
UI dialog.
Time required System UI dialog installation takes about 5 minutes to complete.
Procedure To install System UI dialog, follow these steps:
Step 1. Insert the UI Dialog software diskette into the drive. If needed,
perform steps a. and b which follow.
a. Select “Exit to DOS” from the System Control menu.
b. Select “Yes” from the “Exit to DOS” window.
Step 2. If A> does not display, key in A: and press <ENTER>.
Step 3. Key in INSTALL and press <ENTER>.
Step 4. At the “Xerox DocuPrint 180 UI Dialog Setup” window, select
“Continue”.
Step 5. At the “Xerox DocuPrint 180 UI Dialog Message" window, select
“Continue”.
Step 6. At the “Xerox DocuPrint 180 PC UI System Configuration” window,
select “Continue”.
Step 7. At the “Destination for Xerox DocuPrint 180 UI Dialog” window,
select “Continue”.
Step 8. At the “Xerox DocuPrint 180 UI Dialog Setup Exit Message” window,
select “Exit Windows”.
Step 9. Remove the diskette from the drive. If you are performing an
upgrade, press the Reset button to finish the procedure.