Xerox DocuColor 7000AP, User Manual

Page: 65 / 88

DocuColor 7000AP/8000AP User Guide
11-3
11. Specifications
Tabbed Inserts
Tabbed Inserts can be loaded into the paper trays
as Non-Standard paper.
• When loading, the non-tabbed, short edge of
the tabbed insert should be the lead edge to the
digital press.
• If a jam occurs while running tabbed sets, there
is no recovery procedure.
You have to manually reassemble your
originals and prints, determine where the job
left off, and resume printing or cancel the job
and start again.
• The size of the tabbed insert should be 9 x 11
inch (229 x 279 mm) for letter size tabs (223.5 x
296 mm for A4 equivalent tabs).
• The correct weight of the insert should be
selected on the tray.
• Select Non-Standard size on the paper tray and
on the UI, Tools Mode, input 11 inches or 296
mm for A4 as the X axis and 9 inches or 223.5
mm for A4 as the Y axis dimensions for SEF.
Refer to the System Administration Guide for the
procedure to program non-standard size paper.
Drilled Paper
Three-hole drilled paper can be run from all the
trays either LEF or SEF with the holes facing any
direction.
NOTE: If you are stapling 3-hole drilled paper with
the optional High Capacity Stacker Stapler 80
(HCSS80), refer to the Accessories chapter for
paper loading instructions, based on the position of
the staple.
Drilled paper should be run in the Simplex (1-sided)
and Duplex (2-sided) orientations shown below to
avoid paper jams caused by the holes not aligning
correctly with the paper sensor in the press.