Xerox 4213, Programmer'S Reference Manual

Page: 60 / 246

XES COMMAND LANGUAGE MODE
The command remains in effect until either a Reset command or
another Paper Tray command is received. Thus, it is possible to
change paper trays within a document as many times as you
wish.
If more than one Paper Tray command is entered on a page, the
printer recognises only the last one.
Notes: If Tray sequence mode is enabled, the same size paper trays, the
same paper size, and the same paper type should be installed in
the selected trays.
The factory default tray selection is trays 1 and 2.
Bypass Slot Paper Size
Purpose Indicates the paper size being fed through the bypass slot.
Syntax
E zybn
zyb
Instruction for paper size being manually fed.
n
Indicates paper size selection
Where to place it At the start of the page, before any text prints, and after the
Paper Tray selection command (
E
c9
). If this command is entered
after any printable data, it takes effect on the next page.
Example To print from the bypass tray on letter-size paper, enter:
E
c9
E
zyb0
Notes: This command accommodates paper sizes that will not print on
the 4213. The user may get incorrect printed output that is
formatted for the page size, but is not printed on that page size.
The maximum paper width and length that can be used on the
4213 are 257 mm x 364 mm. The minimum length is 190 mm.
Specifying an n value smaller than the minimum length, such as
n=6 (A6, 105 x 148 mm), or n=C [Postcard, (89 mm x 140 mm)
(3.5” x 5.5”)] will cause the printer to jam.
2–22 XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE