Macintosh EtherTalk Network
Quick install steps
1.
Print the Configuration Sheet. Details are in this document in
Appendix A: Print the Configuration Sheet
.
2.
Check the Configuration Sheet and verify that the EtherTalk is
enabled, the AppleTalk name is correct, the AppleTalk zone is
correct (if used), and the proper connector is enabled. Details are
in the
Technical Information Guide
.
3.
Use the software installer to load print drivers. Details for this are
found in your printer’s
CD-ROM
.
4.
Select your printer and zone (if used) in the
Chooser
.
5.
Send a print job to the printer.
6.
Check the print job for print-quality. If print-quality problems
exist, use the print-quality section of your printer’s
Advanced
Features and Troubleshooting Manual
to correct the problem.
7.
If your print job did not print, see the Troubleshooting section for
your operating system in the
Technical Information Guide
to
correct the problem.
