Xerox -05W, User Manual, Page: 184 / 370

11-8
Initialization Commands
Network Connection
Network Host Name
Initialization File: host= name
Command Line: hostname / protocol
Default Setting: Not applicable
You can make TeemTalk automatically connect to a network host node each time it is
loaded or reset by specifying the host name, protocol and, if necessary, a different
default TSR identifier in the initialization file or on the command line. The
host=
command is used to specify the name of the host. The communications protocol must
be specified on the line below the
host= command using the protocol= command.
On the command line, the host name is immediately followed by a forward slash (/)
then the protocol (as listed in the next section). For example, to specify the host as
pericom and the protocol as CTERM , the command line for TeemTalk-07W32
would look like this:
C:\PROGRAM FILES\TEEMTALK\TT07W.EXE pericom/cterm
Network Protocol
Initialization File: protocol= protocol
Command Line: hostname / protocol
Default Setting: Not applicable
You can make TeemTalk automatically connect to a network host node each time it is
loaded or reset by specifying the host name, protocol and, if necessary, a different
default TSR identifier in the initialization file or on the command line.
In the initialization file, the protocol must be specified on the line immediately below
the
host= command.
The protocol setting can be any one of the following:
TeemTalk for Windows 3.1x:
bapi infoconn lanman netbios pcnfs
bwtcp int6B lanwp netwlat pctcp
cterm int14 lat newt TeemTalkosi
doslanti ipxspx multilan oslan telapi
eiconx25 isdn ncsi pathway winsock