7
Make sure the battery plug is connected inside the
battery compartment.
Set switch to OFF or AUTO mode and allow the solar
panel to absorb direct sunlight for two or more days to
recharge the battery.
Make sure there is no other brighter light source near
the unit at night time.
Once battery is removed from the jacket. Make sure
plug in the solar panel charger after put battery back to
the jacket to reactivate.
The battery does
not fully charge.
While in AUTO mode, if there is frequent activity from
dusk to dawn or consecutive overcast days, the solar panel
may not convert sufficient ambient daylight to recharge the
battery.
Reposition solar panel to receive more sunlight.
Clean dust and debris from solar panel.
Make sure the solar panel cable is not damaged.
The light stays on
continuously
while in AUTO
mode.
Check the motion detector to ensure that it is not
directed towards street traffic or where other movements
may trigger the light needlessly.
The lights on the
receiver do not
work.
Check DVR menu to ensure camera is registered and
auto paired.
There is no
picture on the
monitor, or the
picture is not
clear.
Check that the DVR power supply is working.
Make sure the distance between the DVR and the
light/camera unit does not exceed 50-100 feet.
Check the connection between DVR and TV.
Adjust DVR antenna direction to capture digital signal.
Motion has not
been detected
within the
coverage area.
Check the motion sensor lens for dust or damage.
Avoid installing the light near an air conditioner, central
heater, or hot air flow.
