Resolute User Manual Version 2.5
3
Device Preparation
Making the Connection
No. Name
Function
1
USB-Mini
Provides access for configuration of device for deployment via PC
2
Test Button
Used as a test to check if the device is working properly and should
turn all the LEDs on. It also initiates the device’s connection to its
peripheral devices. Hold the button to reset the device.
3
Radio TNC
Connection to Radio antenna via TNC connector
4
2 BA Ground Stud
Grounding connection for lightning and surge protection
5
Serial/SDI-12/SW
LOAD
Connection to peripheral device via Serial/SDI-12, Serial output
and/or Switched power for peripheral device (14-Pin Female)
6
Power/ENET/CBUS Connection to power supply, ethernet and CBUS connection (10-Pin
Female)
7
Iridium TNC
Connection to Iridium antenna via TNC connector
8
GNSS Type N
Connection to GNSS antenna via Type N connector
9
Cellular TNC
Connection to Cellular antenna via TNC connector
The front panel of the Resolute has up to 7 connectors, depending on the configuration to
connect to various antennas.
The USB (USB Mini) is used as a diagnostic I/O port for the device. Alternatively, Serial 1 on the
14-pin circular Souriau connector can be used as a diagnostic port. The user can set various
settings on the device through this port, as well as receive diagnostic output. It is also where the
device will accept firmware upgrades.
